Threshold Sf-Ber - Cisco ASR 9000 Series Command Reference Manual

threshold sf-ber

threshold sf-ber
To configure the threshold of the Signal Failure (SF) Bit Error Rate (BER) that is used to trigger a link state
change, use the threshold sf-ber command in wanphy configuration mode. To return the Signal Failure (SF)
Bit Error Rate (BER) to the default value, use the no form of this command.
threshold sf-ber exponenet
no threshold sf-ber exponenet
Syntax Description
exponent
Command Default
The default is 3, meaning (10-3).
Command Modes
Wanphy configuration
Command History
Release
Release 5.2.0
Usage Guidelines
Task ID
Task ID
interface
Examples This example shows how to configure the threshold of the Signal Failure (SF) Bit Error Rate (BER):
RP/0/RSP0/CPU0:router # configure
RP/0/RSP0/CPU0:router(config)# controller wanphy 0/6/1/0
RP/0/RSP0/CPU0:router(config-wanphy)# threshold sf-ber 9
RP/0/RSP0/CPU0:router(config-wanphy)#
Related Commands
Command
report sd-ber, on page 1102
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
1116
10-Gigabit Ethernet WAN PHY Controller Commandson the Cisco ASR 9000 Series Router
Value of 10 raised to the n power, where n is the exponent of 10, as in10-n. Valid
values are 3 to 9, meaning 10-3 to 10-9.
Modification
This command was introduced.
Operations
read, write
Description
Enables Signal Degrade (SD) Bit Error Rate (BER) reporting.