Checking Path Length(For Right And Left) Of Feeding Surface - MIMAKI SWJ-320 S2 Maintenance Manual

MAINTENANCE MANUAL > Adjustment > Mechanical Adjustment > Checking path length(for right and left) of feed-
Model SWJ-320S Issued 2013.03.08 Revised

4.3.8 Checking path length(for right and left) of feeding surface

 Outline
If media skew is thought to be caused by the difference of the path lengths, check them.
 Required part
JV5 option: A103240/OPT-J0274 Path Length Measuring Wire Set
 Checking procedure (front of machine)
Pinch roller
ピンチローラ
Tension bar
© 2013 MIMAKI ENGINEERING CO.,LTD.
1. Remove the pinch roller at the right edge and attach the wire tip
with the pinch roller shaft.
OPT-J0274
2. Pass wire as indicated.
Fold back the path and pull wire up over the platen.
OPT-J0274
Roll shaft
F/W ver 1.0 Remark
When you push the pinch roller from above, it comes
off.
Push
Rev.
1.0
1
2
3
4
5
6
7
8
4.3.8 R.1.0 P.1