MIMAKI SWJ-320 S2 Maintenance Manual page 79

MAINTENANCE MANUAL > Adjustment > Adjustment Items > INK PURGE
Model SWJ-320S Issued 2012.07.19 Revised 2013.03.08 F/W ver
4.2.14 INK PURGE
 Ink discharging at part replacement (Liquid supply pump OFF)
FUNCTION
#ADJUST [ENT]
#ADJUST
INK PURGE [ENT]
INK PURGE
CARRIAGE OUT [ENT]
(Purge button enable)
INK PURGE (ON )
COMPLETED [ENT]
INK PURGE (OFF )
COMPLETED [ENT]
Parts replacement
 After parts replacement (Ink charging)
FUNCTION
#ADJUST [ENT]
#ADJUST
INK PURGE [ENT]
INK PURGE
CARRIAGE OUT [ENT]
(Purge button enable)
INK PURGE (ON )
COMPLETED [ENT]
Purge button
© 2013 MIMAKI ENGINEERING CO.,LTD.
1.0
1. Select [#ADJUST] -> [INK PURGE].
2. Press [ENTER] key to move the carriage to the maintenance
position.
3. Turn the ink pump OFF.
[] / [] :Liquid supply pump ON/OFF selection
[ENTER] : End
4. Check the ink color, and press the purge button until no ink is
discharged from the head.
5. Manually perform wiping.
6. Press [ENTER] key to terminate [#INK PURGE].
1. Check that the ink bottle has been set.
2. Select [#ADJUST] -> [INK PURGE].
3. Press [ENTER] key to move the carriage to the maintenance
position.
4. Turn the ink pump ON.
[] / [] :Liquid supply pump ON/OFF selection
[ENTER] : End
5. Insert the air purge jig into the ink port and insert another end of
the jig for discharge into the waste ink tank or tray, and press
the purge button.
Press the button continuous until ink is discharged flow from
end of the jig.
 Remove the air purge jig quickly after
performing to purge, for prevention of air
countercurrent.
6. Manually perform wiping.
7. Press [ENTER] key to end.
Remark
4.2.14
Rev.
1.2
1
2
3
4
5
6
7
8
R.1.2 P.2