Setting Of Overprint; Setting Of Drying Time; Setting Of Left And Right Margins - MIMAKI Tx300P-1800 Operation Manual

Chapter 3 Setup

Setting of Overprint

Sets the number of layers in which ink is to be applied.
Press
1
Press
2
and press the
• SETUP MENU will be displayed.
Press
3
press the the
Press
4
and press the the
• Setting value : Host/ 1 to 9 times
Press the
5
end the setting.

Setting of Drying Time

In the drying time setting, the following items for ink drying
time are set.
• SCAN : Ink drying time for each scanning is set. (During
bidirectional printing, the machine stops for a
certain period of time specified for each of the
outward and return scanning.)
• PRINT END : Ink drying time after printing has been complete
is set.
• When you give priority to the setting at the
RasterLink side, make the setting value "Host".
• "SCAN" set in this machine is displayed as "Pause
Time per Scan" in the RasterLink.
• You cannot specify the print end at the RasterLink
side. When you set this machine to "Host", printing
will be performed in "PRINT END= 0 min." status.
Press
1
Press
2
and press the
• SETUP MENU will be displayed.
Press
3
and press the
Press the
4
3-8
in LOCAL.
(MENU)
to select SETUP 1 to 4,
key.
to select "Overprint" , and
key.
to set number of Overprint,
key.
key several times to
in LOCAL.
(MENU)
to select SETUP 1 to 4,
key.
to select "DRYING TIME",
key.
key.
Press
5
time, and press the
• Set the drying time for canning and after printing
is completed. To enable the drying time specified
in your RIP, select "Host".
• Scanning setting value :
Host or 0.0 sec. to 9.9 sec.
• Print end setting value:
Host or 0 sec. to 120 minutes.
• Item selecting : by the [][] keys
• Time setting : by the [][] keys
Press the
6
end the setting.

Setting of Left and Right Margins

Set a non-printing area along the left and right edges of
the media.
The offset value against the standard margin 20 mm is set
hereupon.
• When you give priority to the setting at the RIP
software side, make the setting value "Host".
• You cannot specify the margins at the attached
RIP software (RasterLink). When you use the
RasterLink, if you set this machine to "Host",
printing will be performed in "Margins for right and
left off set value= 0 mm" status.
• The margin setting is reflected when the media
width is detected.
Press
(MENU)
1
Press to select SETUP 1 to 4,
2
and press the
• SETUP MENU will be displayed.
Press (>>) .
3
Press to select "Margin/L" or
4
"Margin/R", and press the
Press to select a set value, and
5
press the
• Set value : HOST / -10 to 85 mm
Press the
6
end the setting.
• Pay attention to that printing may start on the
media press if a right and left margin is set to 5
mm or less when the media press is used in
printing.
to set drying
key.
key several times to
in LOCAL.
key.
key.
key.
key several times to