MIMAKI SWJ-320 S2 Maintenance Manual page 161

MAINTENANCE MANUAL > Disassembly and Reassembly > Sensors > Y-origin Sensor
Model SWJ-320S Issued 2012.07.19 Revised
6.5.1 Y-origin Sensor
 Work Procedures
Screw
Photo sensor
Main body side
Y-origin sensor BKT
Screw
Carriage side
Y-origin sensor shield plate
© 2013 MIMAKI ENGINEERING CO.,LTD.
F/W ver
Y-origin sensor
1. Open the right maintenance cover, and move the carriage to the
left.
2. Remove the photo sensor.
3. Reverse the disassembly procedure for reassembly.
 Check that the Y-origin sensor shield plate of car-
riage does not contact with the sensor after the sen-
sor is fixed.
In case of contacting, adjust the position, referring
to the left figure.
 After assembling, display [# TEST] -> [SENSOR]
-> [Y ORIGIN]
then check ON/OFF.
Remark
(5.1.2 SENSOR TEST), and
6.5.1
Rev.
1.0
1
2
3
4
5
6
7
8
R.1.0 P.1