Feed Comp.2 - MIMAKI SWJ-320 S2 Maintenance Manual

MAINTENANCE MANUAL > Adjustment > Adjustment Items > FEED COMP.2
Model SWJ-320S Issued 2012.07.19 Revised

4.2.18 FEED COMP.2

DECENTERING pattern
 Function
Item
DECENTERING Compensating the eccentricity of feed roller.
Outputting 16 patterns, and checking/adjusting each pattern.
FEED COMP Compensates basic feeding amount of media. (Provides a baseline value for user compensation value.)
Adjust this when the parameter is initialized.
 By this adjustment, the user compensation value is cleared.
 DECENTERING procedure
<LOCAL>
WIDTH:1000mm
When the media is
MEDIA SET
changed, re-set the width
MEDIA RESET [ENT]
of media and the height of
head in [MEDIA SET].
FUNCTION
#ADJUST [ENT]
#ADJUST
FEED COMP 2 [ENT]
#FEED COMP 2
DECENTERING [ENT]
FEED COMP
#DECENTERING
PRINT [ENT]
#DECENTERING
** PRINT **
Pattern drawing
© 2013 MIMAKI ENGINEERING CO.,LTD.
F/W ver
FEED COMP pattern
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
Pattern0
1. Set a media at the center of printer.
 Perform this adjustment in the state that the
media touches to a floor by slackening the front
and back of media.
 When the media is changed, re-set the width of
media and the height of head.
 For the media width, specified as the whole area
of print, check/adjust at the center and both
ends.
 As the adjusting media, use a photo paper.
2. Select [#ADJUST] -> [FEED COMP 2].
3. Select [DECEBTERING], and press [ENTER].
4. Draw an adjustment pattern.
[ENTER] : Executes drawing.
[] : To the screen for adjustment (Without
[END] : Completes drawing and inputs compensation
1.0 Remark
Outline
drawing)
value.
Rev.
1.0
1
2
3
4
5
6
7
8
4.2.18 R.1.0 P.1