MIMAKI SWJ-320 S2 Maintenance Manual page 20

MAINTENANCE MANUAL > Electrical Parts > Circuit Board Specifications > Main PCB assy.
Model SWJ-320S Issued 2012.07.19 Revised 2013.08.28 F/W ver.
2.3.2 Main PCB assy.
D14 37V, F2 check, CN6
D15 5V, CN7 sensor check
D16 37V, F4 check, CN9
D17 5V?F6 check, CN9
D18 3.3V, FPGA
D19 3.3V, FPGA
D20 3.3V, FPGA
D21 3.3V, FPGA
D32 3.3V, Ethernet connect
D33 3.3V, Ethernet connect
D34 3.3V, Ethernet connect
D35 5V, Power supply check
D36 37V, Power supply check
D37 37V, Power supply check
*1.Only D11 and D35 light on, when main power turn on and power turn off.Another LED light on, when power turn
on.
© 2013 MIMAKI ENGINEERING CO.,LTD.
Huse2 is normal and 37V current is on.
Not used. Not light on.
Huse3 is normal and 37V current is on.
Huse6 is normal and 5V current is on.
It is used many purpose by F/W and FPGA.
It is used many purpose by F/W and FPGA.
It is used many purpose by F/W and FPGA.
It is used many purpose by F/W and FPGA.
It is blinking, when it is connected yellow-LED and LAN cable, and it is
sending and receiving the data.
It is light on, when it is connected green-LED and LAN cable.
It is light on, when it is connected to the network devices which is full duplex.
*1
5V(CN11-5pins) current is on.
37V(CN11-2pins) current is on.
37V(CN11-1pins) current is on.
Remark
2.3.2
Rev.
1.2
1
2
3
4
5
6
7
8
R.1.2 P.3