MIMAKI SWJ-320 S2 Maintenance Manual page 86

MAINTENANCE MANUAL > Adjustment > Adjustment Items > FEED COMP.2
Model SWJ-320S Issued 2012.07.19 Revised
4.2.18 FEED COMP.2
 FEED COMP procedure
<LOCAL>
WIDTH:1000mm
When the media is
MEDIA SET
changed, re-set the width
MEDIA RESET [ENT]
of media and the height of
head in [MEDIA SET].
FUNCTION
#ADJUST [ENT]
#ADJUST
FEED COMP 2 [ENT]
#FEED COMP 2
FEED COMP [ENT]
DECENTERING
#FEED COMP
PRINT [ENT]
#FEED COMP
** PRINT **
Pattern drawing
#FEED COMP
ADJUST = 0
-9999∼9999
© 2013 MIMAKI ENGINEERING CO.,LTD.
1. Set Media at X-origin.
2. Select [#ADJUST] -> [FEED COMP 2].
3. Select [FEED COMP], and press [ENTER].
4. Draw an adjustment pattern.
5. Check/Compensate the adjusting pattern.
Compensation value: -9999 to 9999
OK
A pattern having
width of media is
drawn.
NG
Compensation value
is too large.
NG
Compensation value
is too small.
F/W ver 1.0 Remark
Set the drawing origin as follows;
(Set in [LOCAL] -> [ORIGIN])
≥
X 0, Y > 0
When the media is changed, re-set MEDIA
WIDTH and HEAD HEIGHT.
[ENTER] : Executes drawing.
[] : To the screen for adjustment (Without
drawing)
[END] : Completes drawing and inputs compensation
value.
[] / [] : Changes adjustment values.
[END] : Cancellation of input
For the actual feed compensation, the compensation
value per each feed, which is set in the SETUP func-
tion, is added to this compensation value.
Rev.
1.0
1
2
3
4
5
6
7
8
4.2.18 R.1.0 P.3