MIMAKI SWJ-320 S2 Maintenance Manual page 105

MAINTENANCE MANUAL > Adjustment > Mechanical Adjustment > Checking path length(for right and left) of feed-
Model SWJ-320S Issued 2013.03.08 Revised
4.3.8 Checking path length(for right and left) of feeding surface
Fold back
 Checking procedure (Rear side)
Pinch roller
© 2013 MIMAKI ENGINEERING CO.,LTD.
3. Mark wire with the tape over the platen.
Remove wire and check the path length for the left side in the
same way.
1. Remove the pinch roller at the left edge and attach the wire tip
with the pinch roller shaft.
OPT-J0274
F/W ver 1.0 Remark
Fold back the same path as the media and check the
path length (difference between black wire and red
wire) for the left side with the right front-basis (dif-
ference between black wire and red wire = 0).
<If the left path length is different.>
Displace the gear of the tension bar by tooth up and
down and adjust the path length.
Refer to "INSTALLATION GUIDE
the Stands and the Device]-[13. Attach the take-up
tension bar.]"
When you push the pinch roller from above, it comes
off.
Push
Rev.
1.0
1
2
[4.2 Assembling
3
4
5
6
7
8
4.3.8 R.1.0 P.2