MIMAKI SWJ-320 S2 Maintenance Manual page 183

MAINTENANCE MANUAL > Troubleshooting > Details on Errors and Malfunctions > Concerning Errors and Malfunc-
Model SWJ-320S Issued 2012.07.19 Revised
7.1.1 Concerning Errors and Malfunctions
 Checking Procedure
This section describes troubleshooting procedures for the problems for which error messages are displayed.
1.Identifying the error category
The causes of errors can be classified into the following categories:
 Handling error on the host computer side
 Trouble on the host computer side
 Trouble with the Interface Cable
 Printer handling error
 Printer mechanical trouble
 Printer hardware trouble
 Printer firmware trouble
2.Initial action
Refer to the error message, and judge whether the trouble lies on the host computer side or on the printer side.
 Has any of the interface conditions (printer model setting, command, communication conditions, etc.) been
changed?
 Does the trouble occur under specific conditions?
 Does the same trouble occur repeatedly?
3.Failure on the printer side
Take the following steps to repair the printer.
 Uploading and checking of parameters
 Reinstalling of firmware
 Checking of FFC and cable connections
 Replace the defective part (sensor, etc.) or make the necessary adjustment.
 Replace the PCBs.
4.Repair at the factory
If the error recurs even after the corrective measures specified here are taken, return the printer to the factory of
MIMAKI for repair.
© 2013 MIMAKI ENGINEERING CO.,LTD.
SWJ-
F/W ver
Rev.
Issued
1.0
7.1.1 R.1.0 P.2
1
2
3
4
5
6
7
8