MIMAKI SWJ-320 S2 Maintenance Manual page 135

MAINTENANCE MANUAL > Disassembly and Reassembly > Ink-related Parts > Liquid supply pump
Model SWJ-320S Issued 2012.07.19 Revised 2013.02.15 F/W ver
6.2.3 Liquid supply pump
Proceed with the work after well confirmed the following processes in advance.
 3.1.3 Replacement of the Ink Supply Pump
 Work procedures
to the sub-tank
© 2013 MIMAKI ENGINEERING CO.,LTD.
1. Open the cover LRU, and lay waste around the pump.
Connector
2. Remove the connector of the pump motor.
3. Disconnect the tubes from the pump.
Tube
Holder
4. Remove the ink pump assy. from the holder.
5. Reverse the disassembly procedure for reassembly.
to the ink bottle
Remark
Take care not to pollute the surroundings with
waste ink or washing liquid.
Be careful not to get wrong joint, when you con-
nect the tubes to the pump. (Refer to left figure.)
IN: to the Ink bottle
OUT: to the sub-tank (main body)
Rev.
1.1
1
2
3
4
5
6
7
8
6.2.3 R.1.1 P.1