MIMAKI SWJ-320 S2 Maintenance Manual page 131

MAINTENANCE MANUAL > Disassembly and Reassembly > Ink-related Parts > Ink-tank
Model SWJ-320S Issued 2012.07.19 Revised
6.2.1 Ink-tank
Proceed with the work after well confirmed the following processes in advance.
 3.1.2 Replacement of the INK TANK
 Work Procedures
Ink-tank holder
Liquid level detecting sensor
Ink tank tube
Print head
layout
Near
Ink supply-
side
ing tube
Print head
Ink tank layout (from the backside of machine)
Ink-tank holder
© 2013 MIMAKI ENGINEERING CO.,LTD.
1. Turn the power OFF.
Tube pressing plate
2. Open the cover LR, and remove the tube pressing plate.
3. Remove the carrige from the ink-tank holder.
4. Lay waste around the ink-tank.
5. Disconnect the connector of liquid level detecting sensor from
the junction cable.
6. Remove the tubes(x6), and remove the ink-tank assy..
Ink-tank assy.
7. Perform the assembly by reversing the disassembly procedure.
Liquid level detect-
ing sensor
Air tube
F/W ver Remark
The work can be done even if the ink-tank holder is
not removed.
 The layout of each color ink tank is shown in the
left figure.
 When the ink-tank holder is mounted, fix the
screw at where the height position of ink-tank
holder is at the most upper position.
Raise up to up.
Rev.
1.0
1
2
3
4
5
6
7
Ink-tank holder
8
6.2.1 R.1.0 P.1