For Head Adjustment Jig - MIMAKI SWJ-320 S2 Maintenance Manual

MAINTENANCE MANUAL > Adjustment > Operation Matrix > For Head adjustment jig
Model SWJ-320S Issued 2012.07.19 Revised

4.1.1 For Head adjustment jig

 Outline
As for the head adjustment of SWJ-320S, the dedicated head adjustment jig is established.
The jig is for a service engineer, and does not belong to the machine body.
For the quantity of jig to be used, the number of jigs same as the number of heads is desirable to be prepared.
 Part name and function
Forward/backward
position adjust-
ment screw
Forward/back-
ward position
adjustment bar
 Head adjustment jig attachment procedure
Retract the adjustment bars Retract the adjustment bars
Retract the adjustment bars
Positioning nub
Insert the positioning nub
located on the rear of the
head adjustment jig into
this hole
Rear of adjustment jig
Attach the jig in this
direction
© 2013 MIMAKI ENGINEERING CO.,LTD.
Function list
Tilt adjustment
Forward/backward
screw
position adjustment bar
Tilt adjustment screw
Tilt adjust-
ment bar
The amount of movement per one screw rotation:
1. Store the tip of adjustment bar into the main body by rotating
the tilt adjustment screw and the forward/backward position
adjustment screw counterclockwise.
2. Attach the head adjustment jig to the head.
Near side of head
F/W ver Remark
Rotating
Name
direction
Clockwise
Clockwise
Approx. 500 µm (as a standard)
This adjustment jig is shared with TS500.
Rev.
1.0
Function
The adjustment bar protrudes in
the Y-direction.
The adjustment bar protrudes in
the X-direction.
4.1.1 R.1.0
1
2
3
4
5
6
7
8
P.1