Cap Height Adjustment - MIMAKI SWJ-320 S2 Maintenance Manual

MAINTENANCE MANUAL > Adjustment > Mechanical Adjustment > Cap height adjustment
Model SWJ-320S Issued 2012.07.19 Revised

4.3.1 Cap height adjustment

 Outline
Adjusting the cap height.
 Procedure
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode func-
tions mistakenly during the operation.
ST cover
3 ± 1mm
Fixing screw (blue)
Adjustment screw (Red)
© 2013 MIMAKI ENGINEERING CO.,LTD.
F/W ver 1.0
1. Turn off the main power supply.
2. Set the carriage height to the lowest point (PG: 2mm).
3. Remove the following covers.
• ST lower cover
• ST cover
4. Move the carriage to the flushing position, and measure the
height of head surface and cap.
Specified value: 3 ±1mm (at the front side of cap)
In case of out of the specification, perform the following adjust-
ment continuously.
5. Loosen the fixing screws (4), and adjust the height with the
adjustment screws.
Fixing screw (4): P4x12SMW
Adjustment screw (4): CS4x18 hexagon socket head cap screw
Adjust it so that each cap surface to the head sur-
face is even.
6. Tighten the fixing screws loosened.
7. Check the space between the head surface and each cap.
8. After the adjustment, tighten the locknut of adjustment screw
and fix the adjustment screw.
Remark
4.3.1
Rev.
1.0
1
2
3
4
5
6
7
8
R.1.0 P.1