Table of Contents
Advertisement
MAINTENANCE MANUAL > Disassembly and Reassembly > Repeated winding relations > Feeding Motor Relay
Model
SWJ-320S
Issued 2012.07.19 Revised 2012.08.17 F/W ver
6.7.5 Feeding Motor Relay
After turning off the sub and main power switches, unplug the power cord. Make sure to take 15
minutes before restarting the operation. It is very dangerous if sleep mode functions mistakenly
during the operation.
Additionally, if electric charges are still remaining, it may cause damage to electronic parts or the like.
Work procedures
Relay
Relay socket
Narrower pitch
Wider pitch
Lever (yellow)
© 2013 MIMAKI ENGINEERING CO.,LTD.
Feeding/take-up left side cover
Feeding Motor assy.
Feeding Motor Relay
1. Turn off the main power supply and remove the power plug
from the main body.
2. Remove the following covers.
• Feeding/take-up left side cover
3. Cut the insulation lock tie, and remove the relay from relay
socket pulling out it upward.
For the feeding motor relay and the take-up motor
relay, use the same one.
4. Reverse the disassembly procedure for reassembly.
キ
When the relay is mounted, turn the side of wider
pin-pitch to the lever (yellow) side, and insert it
not to bend the pins of bottom side of relay.
Remark
6.7.5
Rev.
1.1
1
2
3
4
5
6
7
8
R.1.1
P.1
Advertisement
Table of Contents
