MIMAKI SWJ-320 S2 Maintenance Manual page 91

MAINTENANCE MANUAL > Adjustment > Adjustment Items > CHARGE INK
Model SWJ-320S Issued 2012.12.14 Revised
4.2.22 CHARGE INK
PLEASE INSERT INK IC
WRONG INK IC
CANNOT WRITE
UNUSED INK IC
CANNOT WRITE
BACKUP OK?
NO< >YES
** WRITING **
DO NOT REMOVE INK IC
COMPLETED
[ENT]
 Procedures to clear charge ink information inside main body
You can clear charge ink information inside the main body.
Use this function in the following situation.
1)Though you cannot write charge ink information inside the main body as there is no used ink IC, you want to clear
charge ink information of old ink type to replace ink.
 You cannot restore cleared charge ink information. Fully be careful to perform this function.
FUNCTION
#ADJUST [ENT]
#ADJUST
CHARGE INK [ENT]
© 2013 MIMAKI ENGINEERING CO.,LTD.
F/W ver 2.10
3. Select the color to rewrite the amount of charge ink with Press
[] / []key.
 If the charge ink information registered in the main
body is less than 1cc, you cannot write it into the
IC.
 If charge ink information of all colors are less than
1cc, "NONE" is displayed.
 Only one type color can be written into one ink IC.
When you write charge ink information of four
colors, prepare four ink ICs.
.
4. Set the used ink IC
 You can write only into the ink IC usable for SWJ-
320S series.If you set the ink IC other than it, an
error message is displayed.
 You cannot write into an unused ink IC. Set the
used ink IC. If you set an unused ink IC, an error
message is displayed.
5. When you back up charge ink information inside the main body
into the ink IC, select "YES".
6. When you select "YES", writing into the ink IC starts.
 Do not pull out the ink IC during writing.
 Do not turn off the power supply during writing.
7. Press [ENTER].
1. Select [#ADJUST]->[CHARGE INK].
Remark
4.2.22
Rev.
1.0
1
2
3
4
5
6
7
8
R.1.0 P.2