MAINTENANCE MANUAL > Adjustment > Adjustment Items > CAPPING
Model
SWJ-320S
Issued 2012.07.19 Revised
4.2.11 CAPPING
Outline
Adjusts the location for capping and wiper. Adjusted value is saved in the system parameter.
Basically, it is not necessary to make adjustment even when cap assy. has been replaced.
Work Procedures
#ADJUST
CAPPING
[ENT]
#CAPPING
CAP POS.
= 2.0
-20.0~20.0
Cap base
Adjust the posi-
tion so that it
becomes vertical.
#CAPPING
AIR PULL POS. = 2.0
-20.0~20.0
Near side
of device
From the position where the front side of a cap
comes into contact with a head, adjust "1.0" to
the left.
© 2013 MIMAKI ENGINEERING CO.,LTD.
1. Turn the head height adjustment knob screw and set the head
2. Select [#ADJUST CAPPING].
3. Move the carriage so that the leg of the cap base (cap link)
Carriage
4. Adjust the air suction position.
Back of
device
F/W ver
1.0
Remark
height to the lowest position (PG:2mm).
becomes vertical.
[]/[] : Move carriage (adjust)
[ENTER] : Set
1), From the position where the heads and caps are separated,
press the [] key.
2),The back side of the caps will come into contact with the
heads first.
From that position, continue pressing the [] key.
Stop at the position where, among all of the heads, at least
one of them comes into contact with the front side of a cap.
3), From the position where the front side of a cap comes into
contact with a head, press the [] key 10 times. (Shift the
carriage 1.0 to the left)
[]/[] : Move cap (adjust)
[ENTER] : Set
Check/Adjust the followings, if not properly adjust-
able.
Head height
4.3.1 Cap height adjustment
Rev.
1.0
1
2
3
4
5
6
7
8
4.2.11
R.1.0
P.1