Table of Contents
Advertisement
Chapter 3 Setup
Press the
4
Press
5
time, and press the
• Set the drying time for scanning is completed. To
enable the drying time specified in your RIP,
select "Host".
• Scanning setting value :
Host or 0.0 sec. to 9.9 sec.
• Item selecting : by the [][] keys
• Time setting
Press the
6
to end the setting.
Setting of Left and Right Margins
Set a non-printing area along the left and right edges of
the media.
The offset value against the standard margin 15mm is set
hereupon.
• The margin setting is enabled only if the media
detection method is set to "AUTO".
• The margin setting is reflected when the media
width is detected.
Press the
1
Local.
Press
2
press the
• Setup menu appears.
Press the
3
Press
4
"Margin/R" , and press the
Press
5
press the
• Set value : -10 to 85 mm
Press the
6
end the setting.
• Pay attention to the settings of the right and left
margins when printing with the media press. If any
of the margins is set to a negative value, printing
may start from a position on the media press.
Setting of Refresh
Sets the interval of refresh performed during printing.
Press the
1
Local.
3-8
key.
to set drying
key.
: by the [][] keys
key several times
key in
(MENU)
to select SETUP 1 to 4, and
key.
(>>) .
to select "Margin/L" or
key.
to select a set value, and
key.
key several times to
key in
(MENU)
Press
to select SETUP 1 to 4, and
2
press the
• Setup menu appears.
Press the
3
Press
to select "Refresh" , and
4
press the
Press
to select a set value, and
5
press the
• Set value : Host/Lv.0 to Lv.3.
Press the
6
end the setting.
Setting of Vacuum Fan
Sets the absorbability of the media.
By setting the absorption power to match the media, you
can prevent print errors due to media rise-up.
Press the
1
Local.
Press
to select SETUP 1 to 4, and
2
press the
• Setup menu appears.
Press the
3
Press
to select "Vacuum Fan" ,
4
and press the
Press
to select a set value, and
5
press the
• Set value : Host/Weak /Standard/ Strong/ OFF
If you choose any other option than "OFF"
6
in step 4, press
to constantly operate the vacuum fan, and
press the
• ON :
Vacuum fan is constantly on.
• OFF : Vacuum fan is only on when printing or
performing jog operation.
Press the
7
end the setting.
• When switch the setting 1 to 4 /Temporary or copy
the setting, there is a case that the setting screen
of vacuum fan is displayed.
Setting of Print Speed
Changes the media feeding speed and scanning spped in
printing.
key.
(<<) .
key.
key.
key several times to
key in
(MENU)
key.
(<<) .
key.
key.
, choose whether
key
key several times to
Advertisement
Table of Contents
