Table of Contents
Advertisement
MAINTENANCE MANUAL > Adjustment > Mechanical Adjustment > Adjustment of the Wiper Height
Model
SWJ-320S
Issued 2012.07.19 Revised
4.3.2 Adjustment of the Wiper Height
Outline
Adjust the height of the wiper.
Procedure
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode func-
tions mistakenly during the operation.
ST cover
0.5~1.0mm
Carriage
Wiper
Fixing screw (blue)
Adjustment screw (Red)
© 2013 MIMAKI ENGINEERING CO.,LTD.
F/W ver
1.0
1. Turn off the main power supply.
2. Set the carriage height to the highest point (PG: 4mm).
3. Remove the following covers.
• ST lower cover
• ST cover
4. Move the carriage up to the top of wiper, and measure the pro-
truding amount of the tip of wiper from the bottom surface of
carriage.
Specified value: 0.5 ~ 1.0 mm
In case of out of the specification, perform the following adjust-
ment continuously.
5. Loosen the fixing screws (4), and adjust the height with the
adjustment screws.
Fixing screw (4): P4x12SMW
Adjustment screw (4): CS4x16 Cap bolt
At both ends of wiper blade and at the front and
back positions of wiper, a space from the carriage
should be within the specified.
6. Tighten the fixing screws loosened.
7. After the adjustment, tighten the locknut of adjustment screw
and fix the adjustment screw.
Remark
4.3.2
Rev.
1.0
1
2
3
4
5
6
7
8
R.1.0
P.1
Advertisement
Table of Contents
