MAINTENANCE MANUAL > Disassembly and Reassembly > Pressurizing relations > Lighting LED assy.
Model
SWJ-320S
Issued 2012.07.19 Revised
6.6.5 Lighting LED assy.
After turning off the sub and main power switches, unplug the power cord. Make sure to take 15
minutes before restarting the operation. It is very dangerous if sleep mode functions mistakenly
during the operation.
Additionally, if electric charges are still remaining, it may cause damage to electronic parts or the like.
Work procedures
Inside of bracket of the purge part
Bracket of the lighting LED assy.
Bracket of the lighting LED assy.
screw(x2)
Glass: Attention to damage.
Lighting LED cover
Lighting LED
inside cover
© 2013 MIMAKI ENGINEERING CO.,LTD.
1. Turn off the main power supply and remove the power plug
Bracket of the purge part.
from the main body.
2. Unscrew the screws, and remove the bracket of the purge part.
3. Disconnect the relay connector of the lighting LED assy.
4. Unscrew the screws, and remove the bracket of the lighting
LED assy..
Connector
5. Unscrew the screws, and remove the lighting LED assy. from
キ
the bracket.
6. Reverse the disassembly procedure for reassembly.
Lighting LED assy.
F/W ver
Remark
Lighting LED assy.
For the lighting LED cover, handle it with care
not to damage since the glass has been used.
Rev.
1.0
1
2
3
4
5
6
7
8
6.6.5
R.1.0
P.1