Print Adjust - MIMAKI SWJ-320 S2 Maintenance Manual

MAINTENANCE MANUAL > Adjustment > Adjustment Items > PRINT ADJUST
Model SWJ-320S Issued 2012.07.19 Revised 2013.02.15 F/W ver

4.2.8 PRINT ADJUST

 Outline
Adjust the ink landing position.
 Work Procedures
#ADJUST
PRINT ADJUST[ENT]
#PRINT ADJUST
:720Std
:540Std
:720Hi
:1080Std
:BASIS SET 720std
#PRINT ADJUST
SELECT :SiDir
:ReDir
:BiDir
#PRINT ADJUST
SiDir :PRINT
#PRINT ADJUST
** PRINTING **
720std SiDir WF1
H1A-H1B : 0.0
-99.9∼99.9
#PRINT ADJUST
H1A-H1C
H1A-H1D
H1A-H2A
:
H1A-H2D
SiDir/ReDir pattern
H1A (Reference lines)
H1A
H4A
H4B
H3C
H4C
H3D
H4D
© 2013 MIMAKI ENGINEERING CO.,LTD.
1. Select [#ADJUST / PRINT ADJUST].
2. Select [720Std].
3. Select the correction item.
4. Print.
5. Enter the correction values.
H2A
H2B
H2C
H2D
H1A (Reference lines)
H1A
H3A
H3B
1.0 Remark
Perform all types, SiDir, ReDir, and BiDir.
Due to the differences in distance between platen
and heads, the adjustment position of the refer-
ence lines may vary depending on the location.
Be sure to verify all patterns and enter correction
values so that the variation is kept to a minimum.
Figure when viewed using a magnifying lens
H1B
H1C
H1D
Enter a correction value in the positive direction
Enter a correction value in the negative direction
Rev.
1.1
1
2
3
4
5
6
7
Reference lines
Adjustment lines
8
4.2.8 R.1.1 P.1