Table of Contents
Advertisement
MAINTENANCE MANUAL > Adjustment > Mechanical Adjustment > Slack sensor Optical axis adjustment
Model
SWJ-320S
Issued 2012.07.19 Revised
4.3.7 Slack sensor Optical axis adjustment
Outline
Adjusting the mounting angle of the feeding slack sensor assy or the take-up slack sensor assy.
Procedure
Manual switch
Check if the roll shaft
rotation or stop.
A hand up and down
*The figure shows the take-up slack sensor.
© 2013 MIMAKI ENGINEERING CO.,LTD.
1. Turning the power ON.
2. Set the manual switch of the take-up (feed) machine to
"AUTO" (the lower side).
3. Set the direction switch to the normal rotation or reverse rota-
tion (the direction not neutral).
Direction switch
4. Loosen the fixing screws (x2) on the bottom surface of bracket.
5. Adjust the orientation of sensor so as to react by directing it to
the reflector.
Fixing screw(x2)
*The figure shows the
feeding slack sensor.
6. Put a hand between the sensor and reflector, and check the reac-
tion of sensor (the running or stop of roll shaft).
F/W ver
1.0
Remark
Feeding slack sensor assy.:
Feeding motor rotating in the light-passing condition
Take-up slack sensor assy.:
Take-up motor stopping in the light-passing condition
Rev.
1.0
1
2
3
4
5
6
7
8
4.3.7
R.1.0
P.1
Advertisement
Table of Contents
