MIMAKI SWJ-320 S2 Maintenance Manual page 138

MAINTENANCE MANUAL > Disassembly and Reassembly > Drive System > X-axis Motor assy.
Model SWJ-320S Issued 2012.07.19 Revised
6.3.1 X-axis Motor assy.
 Work procedures
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode func-
tions mistakenly during the operation.
Proceed with the work after well confirmed the following processes in advance.
 3.2.1 Replacement of the X-axis Motor
X belt
Loosen
X-motor BKT2
X-axis motor
Screw
© 2013 MIMAKI ENGINEERING CO.,LTD.
1. Turn off the main power supply.
2. Loosen the screws fixing the X-motor BKT2 to make the belt
tension free, and then remove the X-belt from the X-drive pul-
ley.
X drive pulley
3. Open the cover LR, and disconnect the connector.
4. Remove the X-axis Motor from the X-motor BKT2.
5. Reverse the disassembly procedure for reassembly.
F/W ver Remark
Remove it paying attention to the motor dropping.
Rev.
1.0
1
2
3
4
5
6
7
8
6.3.1 R.1.0 P.1