Setting Of Left And Right Margins; Setting Of Uv Mode - MIMAKI UJV55-320 Operation Manual

Chapter 3 Setup

Setting of Left and Right Margins

Set a non-printing area along the left and right edges of
the media.
The offset value against the standard margin 15mm is set
hereupon.
• The margin setting is enabled only if the media
detection method is set to "AUTO".
• The margin setting is reflected when the media
width is detected.
1
Press the
Local.
2
Press
press the
• Setup menu appears.
3
Press the
4
Press
"Margin/R" , and press the
5
Press
press the
• Set value : -10 to 85 mm
6
Press the
end the setting.
• Pay attention to the settings of the right and left
margins when printing with the media press. If any
of the margins is set to a negative value, printing
may start from a position on the media press.
3-8
key in
(MENU)
to select SETUP 1 to 4, and
key.
(>>) .
to select "Margin/L" or
key.
to select a set value, and
key.
key several times to

Setting of UV mode

Set the amount of light for the UV lamp of the LED UV
device.
• The color tone may differ if any of the UV mode
settings is changed. Check in advance that the
color tone will not be affected.
Setting of Mode
There are two types of setting of mode available as shown
below.
Setting item
Prints with an amount of light recommended
AUTO
for each of the printing modes.
Select this if the curing level is not good when
MANUAL
AUTO is selected.
Normally, select "AUTO".
If the level of ink curing is strong/weak, adjust the UV lamp
intensity by using "Light Adjust" in the "AUTO" settings.
If adjustment cannot be made even by using "Light Adjust" in
the "AUTO" settings, select "MANUAL".
 To adjust the amount of light in the "AUTO"
settings
1
Press the
Local.
2
Press to select SETUP 1 to 4, and
press the
• Setup menu appears.
3
Press the
4
Press to select "UV Mode" , and
press the
5
Press the
6
Press to select "AUTO", and
press the
7
Press to select "Light Adjust",
and press the
8
Press to set the adjustment value
for the intensity of the LED UV device, and
press the
• Set value : -50% to +50%
• If you set this value to 0%, the machine applies an
intensity recommended for each of the printing
modes.
• Setting a negative value reduces the intensity;
setting a positive value increases the intensity.
9
Press the
end the setting.
Descriptions
key in
(MENU)
key.
(>>) .
key.
key.
key.
key.
key.
key several times to