MIMAKI SWJ-320 S2 Maintenance Manual page 172

MAINTENANCE MANUAL > Disassembly and Reassembly > Repeated winding relations > Take-up Motor assy.
Model SWJ-320S Issued 2012.07.19 Revised 2012.08.17 F/W ver
6.7.4 Take-up Motor assy.
After turning off the sub and main power switches, unplug the power cord. Make sure to take 15
minutes before restarting the operation. It is very dangerous if sleep mode functions mistakenly
during the operation.
Additionally, if electric charges are still remaining, it may cause damage to electronic parts or the like.
 Work procedures
Loosen the screw.
Take-up motor gear
© 2013 MIMAKI ENGINEERING CO.,LTD.
Take-up Motor assy.
Feeding/take-up left side cover
1. Turn off the main power supply and remove the power plug
from the main body.
Take-up Motor
assy.
2. Remove the following covers.
• Feeding/take-up left side cover
3. Remove the terminal block cover, and disconnect the take-up
motor cables (A4, A23, A24) from the terminal block, loosen-
ing the screw.
Terminal block
4. Remove the screw, and remove the take-up motor BKT.
screw(x5)
Take-up motor BKT
5. Loosen the set screw, and remove the take-up motor gear.
Take-up motor gear
6. Remove the screw, and remove the take-up motor assy..
Set screw
7. Reverse the disassembly procedure for reassembly.
Remark
6.7.4
Rev.
1.1
1
2
3
4
5
6
7
8
R.1.1 P.1