MIMAKI SWJ-320 S2 Maintenance Manual page 187

MAINTENANCE MANUAL > Troubleshooting > Details on Errors and Malfunctions > List of Error Messages
Model SWJ-320S Issued 2012.07.19 Revised 2012.12.14 F/W ver
7.1.2 List of Error Messages
 List of Error Messages ?4/5?
No. LCD
ERROR 410
X ROLLER Z ORG
39
ERROR 426
FEEDER UNIT
40
ERROR 50a
Y ORIGIN
41
ERROR 50c
MEDIA UNDETECTED
42
ERROR 50f
L-SCALE BLACK
43
ERROR 607
44
CAP CLEANING
ERROR 60f
45
Expiration
ERROR 629
INK EXPIRATION(1M)
46
© 2013 MIMAKI ENGINEERING CO.,LTD.
Cause
X origin detection error
(The X origin cannot be found.)
Feeding sensor abnormality
(The feeding sensor status is not stable.)
Y-origin error
(Origin of Y-axis can not be detected)
Print area setting is not performed.
(You performed the printing operation or
the transfer operation without setting the
printing area.)
Liner Scale error
Time for cap cleaning
Ink expiration date has passed.
Ink expiration date has passed
(more than one month ago).
Remark
1.0
List of Countermeasures
1. Perform [#TEST SENSOR TEST] -> [X ORIGIN] and
check. (Move the wiper back/ forth and check that ON/
OFF display is changed.)
2. Check that there is no loose in attaching the X origin sensor
shading plate and that the shading plate does not tilt.
3. Manually rotate the X pulley and check that the X origin
sensor does not contact the shading plate.
4. Pull out/ insert the FFC between MAIN PCB and Central-
IO PCB.
5. Replace the X origin sensor with new one.
6. Replace the FFC between MAIN PCB and Central-IO PCB.
7. Replace the Central-IO PCB with a new one.
1. Check that you did not select the roll without using the
feeder unit.
2. Check the feeding direction switch and the feeding manual
switch.
3. Check the junction cable (connection between the main
body and the leg).
4. Check that you did not mess up cable of the feeding sensor.
1. Execute and confirm [#TEST SENSOR TEST]->
[Y-ORG].(Confirm that the ON/OFF display is switched by
moving the carriage left and right.)
2. Execute [#TEST CHECK ENCODER].
3. Check in manual if the Head assy. (carriage) moves left and
right smoothly.
4. Check the connector connection of Y-origin Sensor and
Linear Encoder.
5. Replace the Y-origin Sensor or Linear Encoder with a new
one.
6. Check the assembly and connector connection of Y-axis
Motor.
7. Replace the Y-axis Motor with a new one.
8. Replace the HDC PCB with a new one.
9. Replace the MAIN PCB with a new one.
1. Set the printing area.
1. Check the assembly position of Linear Scale and Encoder
PCB assy..
2. Check Linear Scale (scratches or dirtiness or so.)
3. Replace the Linear Scale with a new one.
4. Replace the Encoder PCB assy. with a new one.
(Refer to 6.4.4)
1. Perform station maintenance.
You can use ink continuously.
1. Prepare new (unexpired) ink.
2. If the error occurs even if the ink expiration date has not
passed, reset the date from [#ADJUST] -> [TIME SET] and
restart.
Rev.
1.1
1
2
3
4
5
(Refer to 6.3.2)
(Refer to 6.4.7)
6
(Refer to 3.3.1)
7
8
7.1.2 R.1.1 P.4