Setting Of Left And Right Margins; Setting Of Vacuumfan; Setting Of Feed Speed - MIMAKI JV150-130 Operation Manual

Chapter 3 Setup

Setting of Left and Right Margins

Set a non-printing area along the left and right edges of
the media.
The offset value against the standard margin 15mm is set
hereupon.
• When you give priority to the setting at the RIP
software side, make the setting value "Host".
• You cannot specify the margins at the attached
RIP software (RasterLink). When you use the
RasterLink, if you set this machine to "Host",
printing will be performed in "Margins for right and
left off set value= 0 mm" status.
• The margin setting is reflected when the media
width is detected.
1
Press the
LOCAL.
2
Press
and press the
• SETUP MENU will be displayed.
3
Press the
4
Press
"Margin/R", and press the
5
Press
press the
• Set value : HOST / -10 to 85 mm
6
Press the
to end the setting.
• Pay attention to that printing may start on the
media press if a right and left margin is set to 5
mm or less when the media press is used in
printing.
3-8
key in
(MENU)
to select SETUP 1 to 4,
key.
(>>) .
to select "Margin/L" or
key.
to select a set value, and
key.
key several times

Setting of VacuumFan

Sets the absorbability of the media.
By setting the absorption power to match the media, you
can prevent print errors due to media rise-up.
1
Press the
LOCAL.
2
Press
and press the
• SETUP MENU will be displayed.
3
Press the
4
Press
and press the
5
Press the
6
Press
press the
• Set value : HOST/WEAK /STANDARD/ STRONG
7
Press the
to end the setting.

Setting of Feed Speed

Changes the media feeding speed in printing.
1
Press the
LOCAL.
2
Press
and press the
• SETUP MENU will be displayed.
3
Press the
4
Press
SPEED", and press the
5
Press the
6
Press
press the
• Set value : HOST / 10 to 200%
7
Press the
to end the setting.
key in
(MENU)
to select SETUP 1 to 4,
key.
(>>) .
to select "VACUUM FAN",
key.
key.
to select a set value, and
key.
key several times
key in
(MENU)
to select SETUP 1 to 4,
key.
(>>) .
to select ""FEED
key.
key.
to select a set value, and
key.
key several times