MAINTENANCE MANUAL > Disassembly and Reassembly > Drive System > Linear Encoder Scale
Issued 2012.02.29 Revised
Model
SWJ-320S
6.3.3 Linear Encoder Scale
Scale holder
Screw
Linear Encoder Scale
Linear Encoder Scale
Encoder scale mounting spring
© 2013 MIMAKI ENGINEERING CO.,LTD.
F/W ver.
4. On the left end of Y-bar, unscrew the screws, and remove the
scale holder.
5. On the right edge, disengage the encoder scale mounting
spring, and then remove the linear encoder.
While at work, be sure not to attach fingerprints
or oil to the linear encoder scale. Also, pay atten-
tion not to break or scratch it. (If contaminated,
clean the scale with a neutral detergent.)
6. Reverse the disassembly procedure for reassembly.
Remove the double sided tape off the scale holder.
Do not stick it after replaced.
Remark
6.3.3
Rev.
1.1
1
2
3
4
5
6
7
8
R.1.1
P.2