Y-Drive Belt (Long) Tension Adjustment - MIMAKI SWJ-320 S2 Maintenance Manual

MAINTENANCE MANUAL > Adjustment > Mechanical Adjustment > Y-drive belt (Long) tension adjustment
Model SWJ-320S Issued 2013.03.08 Revised

4.3.5 Y-drive belt (Long) tension adjustment

 Outline
Adjusting the belt tension of Y-driving belt (long belt attached to the printer head carriage), using a tension gauge.
 Specified value
The amount of deflection at pushed by a tension gauge (400gf): 4.8 - 5.2mm
 Adjustment procedure
adjusting screw
length of belt span
adjustment position
at 500mm
carriage: move to left
adjusting screw
turn to adjust
© 2013 MIMAKI ENGINEERING CO.,LTD.
Y-drive belt (Long)
Y motor Assy.
1. Move the printer head carriage to left so that the belt span
1000mm
2. Press the tension gauge at the right angle with 400 gf power to
3. Check the amount of deflection.
4. Turn two adjusting screws which is at the left side of the main
F/W ver 1.0 Remark
becomes 1000mm length.
the belt center of belt span (at 500mm to the end).
The amount of deflection: 4.8 - 5.2mm
body for adjusting the above proper value.
Adjust that the length of two screws is same.
length of 2 screws is same
Rev.
1.0
1
2
3
4
5
6
7
8
4.3.5 R.1.0 P.1