MIMAKI SWJ-320 S2 Maintenance Manual page 70

MAINTENANCE MANUAL > Adjustment > Adjustment Items > PRINT ADJUST
Model SWJ-320S Issued 2012.07.19 Revised 2013.02.15 F/W ver
4.2.8 PRINT ADJUST
BiDir pattern
Figure when viewed
using a magnifying lens
Enter a correction value in the positive direction
#PRINT ADJUST
:BASIS SET 720std
© 2013 MIMAKI ENGINEERING CO.,LTD.
1.0 Remark
Adjustment lines
Reference lines
Reference lines
Adjustment lines
Enter a correction value in the negative direction
6. Select [BASIS SET 720std] and press the [ENTER] key. The
values adjusted in 720std are set as the correction values of
other modes.
The values set using [BASIS SET] are values cal-
culated as a guideline for correction values. Thus,
the actual ink landing position may be mis-
aligned. Be sure to adjust the landing position for
each mode that will be used.
7. Perform adjustments similar to 720Std in modes other than
720Std.
Rev.
1.1
1
2
3
4
5
6
7
8
4.2.8 R.1.1 P.2