Setting Of Left And Right Margins; Setting Of Vacuum Fan; Setting Of Feed Speed; Setting Of Maps - MIMAKI JV300-130 A Operation Manual

Chapter 3 Setup

Setting of Left and Right Margins

Set a non-printing area along the left and right edges of
the media.
The offset value against the standard margin 15mm is set
hereupon.
• When you give priority to the setting at the RIP
software side, make the setting value "Host".
• You cannot specify the margins at the attached
RIP software (RasterLink). When you use the
RasterLink, if you set this machine to "Host",
printing will be performed in "Margins for right and
left off set value= 0 mm" status.
• The margin setting is reflected when the media
width is detected.
Press the
1
LOCAL.
Press
2
and press the
• SETUP MENU will be displayed.
Press
3
"Margin/R", and press the
Press
4
press the
• Set value : HOST / -10 to 85 mm
Press the
5
to end the setting.
• Pay attention to that printing may start on the
media press if a right and left margin is set to 5
mm or less when the media press is used in
printing.

Setting of Vacuum Fan

Sets the absorbability of the media.
By setting the absorption power to match the media, you
can prevent print errors due to media rise-up.
Press the
1
LOCAL.
Press
2
and press the
• SETUP MENU will be displayed.
Press the
3
Press
4
and press the
Press the
5
Press
6
press the
• Set value : HOST/WEAK /STANDARD/ STRONG
3-8
(MENU) key in
to select SETUP 1 to 4,
key.
to select "Margin/L" or
key.
to select a set value, and
key.
key several times
(MENU) key in
to select SETUP 1 to 4,
key.
(>>) .
to select "VACUUM FAN",
key.
key.
to select a set value, and
key.
Press the
7
to end the setting.

Setting of Feed Speed

Changes the media feeding speed in printing.
Press the
1
LOCAL.
Press
2
and press the
• SETUP MENU will be displayed.
Press the
3
Press
4
SPEED", and press the
Press the
5
Press
6
press the
• Set value : HOST / 10 to 200%
Press the
7
to end the setting.

Setting of MAPS

The MAPS (Mimaki Advanced PassSystem) function to
disperse the pass boundary to make the feeding stripes
less visible.
With this function, the degree of application of MAPS can
be changed.
• MAPS provides two setting options: "AUTO" and
"MANUAL" MAPS applies the one most suitable
for your printing conditions, so please normally
use "AUTO" (default value).
• Changing the MAPS settings may change the
color tone. Check the effects before use.
• MAPS may not be effective depending on image to
be printed. Use it after checking effect in advance.
key several times
key in
(MENU)
to select SETUP 1 to 4,
key.
(>>) .
to select ""FEED
key.
key.
to select a set value, and
key.
key several times