Table of Contents
Advertisement
MAINTENANCE MANUAL > Troubleshooting > Details on Errors and Malfunctions > List of Warning Messages
Model SWJ-320S Issued 2012.07.19 Revised
7.1.3 List of Warning Messages
List of Warning Messages
No.
Message
List of Ink Error (Checking by guidance)
1 <LOCAL>
Some ink are expired.
EXPIRATION
MCYK
2 <LOCAL>
Some ink are expired.
EXPIRATION(1M)
(One month has passed after
MCYK
the expiration date.)
3 <LOCAL>
Some ink are expired.
EXPIRATION(2M)
(Two months have passed
MCYK
after the expiration date.)
Warning Messages
(LOCAL)
4 <LOCAL>
The count of the wiper
Replace WIPER [MNT]
exceeded the specified
amount.
5 <LOCAL>
No more media is available
** NO MEDIA **
during print.
6 <LOCAL>
Data has already been
DATA REMAIN
received.
7 <LOCAL>
Ink near end (A small amount
INK NEAR END
of ink left)
MCYK
8 <LOCAL>
Ink filling into the sub-tank
SUPPLY INK :MCYK
has failed.
Warning Messages
(Operation)
9 CAN'T OPERATE
The media has not been
:MEDIA UNDETECTED
detected.
10 CAN'T OPERATE
The data has been received.
:DATA REMAIN
Warning message (Ink IC charge)
11 WRONG INK IC
The ink IC cannot be read cor-
:CANNOT CHARGE
rectly.
12 INK TYPE
The type of ink IC inserted is
:CANNOT CHARGE
different.
13 INK IC ALREADY
The ink IC, which has been
USED
charged once, was inserted.
:CANNOT CHARGE
14 INK EXPIRATION (2M)
The ink IC elapsing for more
:CANNOT CHARGE
than two months from the ink
expiry date was inserted.
© 2013 MIMAKI ENGINEERING CO.,LTD.
F/W ver
Cause
Check the expiration date of the ink.
Be careful that the expiration date is coming soon. It can be used up to
two months later.
Be careful that the expiration date is coming soon. You can use up to the
next month. The red LED blinks.
Replace the ink bottle where a warning occurs, and charge the ink.
Press the [MAINT] key, and replace the wiper.
Execute the media reset.
Press the REMOTE key and perform printing.
Or, perform data clear.
Check the remaining amount of ink of ink bottle.
(Be careful that ink end is coming soon.)
1. Check that there is no ink clogging in ink routes.
2. Check that the ink pump works normally.
3. Check the ink tank sensor.
Perform the media width detection.
Back to the local display and then press "REMOTE" key for print start
or clear the print data.
1. Pull out IC chip once, then reset the chip again.
2. If the same error occurs after setting the new ink IC chip, replace the ink IC
slot and the main circuit board.
Check whether the actual filling ink and the set ink type are matched.
Set the new ink IC chip.
Replace the ink bottle with the other bottle that is not expired.
Remark
1.0
Corrective Measures
Rev.
1.0
1
2
3
4
5
6
7
8
7.1.3
R.1.0
P.1
Advertisement
Table of Contents
