Table of Contents
Advertisement
MAINTENANCE MANUAL > Adjustment > Adjustment Items > [HEAD ADJUST] Carriage base tilting
Model SWJ-320S Issued 2012.07.19 Revised
4.2.2 [HEAD ADJUST] Carriage base tilting
Outline
For the tilt adjustment procedure using the head adjustment jig of this machine, the adjustment is carried out in the
manner that it moves the front side of head unit left and right, pushing the back side of head unit to the contact end
surface.
The head unit itself has been so adjusted that no tilting occurs if the head unit is mounted, pushing the unit to the con-
tact end surface.
Therefore, at shipped, it is in the condition that the right side of head unit is pressed to the contact end surface.
The head unit is possible to tilt in the right direction but not possible in the left direction since it is in the condition
that the head unit is pressed to the right side.
Head
unit
Contact end
surface
This adjustment is performed when the head unit is required to be tilted in the left direction due to the accuracy vari-
ation of head unit.
The tilting of all head units are adjustable by tilting the carriage base to the left so that the head unit comes in straight,
referring to the head unit most slanting to the right.
Tilting more than acceptable
range to right
After this adjustment, check the tilting, the stagger and the front and back position of all heads,
and execute each adjustment if required.
© 2013 MIMAKI ENGINEERING CO.,LTD.
F/W ver 2.20 Remark
Tilted to the left
Tilted to the right
Not possible to tilt in the
left direction
Tilt Carriage base, to straighten
Head most slanting to right.
Possible to tilt in the
Head
right direction
unit
Check/Adjust tilt of each head
unit
4.2.2
R.1.0
Rev.
1.0
1
2
3
4
5
6
7
8
P.1
Advertisement
Table of Contents
