MAINTENANCE MANUAL > Adjustment > Adjustment Items > HEAD WASH
Model
SWJ-320S
Issued 2012.07.19 Revised 2013.03.08 F/W ver
4.2.13 HEAD WASH
Function
Cleans the ink path inside the head, inktank and tube.
When modifying ink type or ink set, empties the ink out of the path and cleans the inside using the washing liquid.
Work Procedures
FUNCTION
#ADJUST
[ENT]
#ADJUST
HEAD WASH
[ENT]
WIPER CLEANING
COMPLETED
[ENT]
SET WASH BOTTLE
COMPLETED
[ENT]
WASHING
PLEASE WAIT
CHECK SUBTANK
RETRY <
> NEXT
© 2013 MIMAKI ENGINEERING CO.,LTD.
1. Remove the following covers.
•Right maintenance cover U
•Right maintenance cover C
•Head cover
•Rear cover LU
2. Select [#ADJUST] -> [HEAD WASH], and press [ENTER]
key.
3. Clean the wiper. Press [ENTER] key after completing to clean.
[ENTER]: To next
4. Set the wash bottle, and press the [ENTER] key.
You must set all channels to cleaning bottles.
Set so that the tips of the ink bottle pipes come
into contact with the bottom of the bottles.
When washing can not be completed, below message is dis-
played on the screen.
ERR(DISCHARGE) :MCYK
END <
> RETRY
• Check the position of the sub-tank sensor, leak from the
cap, performance of the suction pump.
•
ERR(SUPPLY)
:MCYK
END <
> RETRY
• Check the position of the sub-tank sensor, performance of
the ink supply pump.
5. Check the sub-tank state, and select the key.
R
e
t
r
[]:Retry washing
y
[]:To next
1.0
Remark
[]:Go to "LOCAL"
[]:Resume washing
[]:Go to "LOCAL"
[]:Resume washing
4.2.13
Rev.
1.2
1
2
3
4
5
6
7
8
R.1.2
P.1