MIMAKI SWJ-320 S2 Maintenance Manual page 106

MAINTENANCE MANUAL > Adjustment > Mechanical Adjustment > Checking path length(for right and left) of feed-
Model SWJ-320S Issued 2013.03.08 Revised
4.3.8 Checking path length(for right and left) of feeding surface
ピンチローラ
Return path
Tensio bar
© 2013 MIMAKI ENGINEERING CO.,LTD.
2. Pass wire as indicated.
Fold back the path and pull wire up over the platen.
OPT-J0274
Feeding roller
3. Mark wire with the tape over the platen.
Remove wire and check the path length for the right side in the
same way.
F/W ver 1.0 Remark
Fold back the same path as the media and check the
path length (difference between black wire and red
wire) for the left side with the right front-basis (dif-
ference between black wire and red wire = 0).
<If the left path length is different.>
Displace the gear of the tension bar by tooth up and
down and adjust the path length.
Refer to "INSTALLATION GUIDE
the Stands and the Device]-[15. Attach the feeding
tension bar.]"
Rev.
1.0
1
2
3
4
5
6
[4.2 Assembling
7
8
4.3.8 R.1.0 P.3