MIMAKI SWJ-320 S2 Maintenance Manual page 64

MAINTENANCE MANUAL > Adjustment > Adjustment Items > [HEAD ADJUST] STAGGER ADJUST
SWJ-320S
Model Issued 2013.03.08 Revised
4.2.6 [HEAD ADJUST] STAGGER ADJUST
 Head stagger check procedure
<LOCAL>
width:1000mm
[FUNCTION]
FUNCTION
#ADJUST [ENT]
#ADJUST
HEAD ADJUST [ENT]
#HEAD ADJUST
STAGGER ADJUST [ENT]
#STAGGER ADJUST
PRINT START [ENT]
Headline
Headline
Headline
<Scope image>
Dot of Headline1
1
Overlapped
2
by 4-dots
3
4
Dot of Headline2
© 2013 MIMAKI ENGINEERING CO.,LTD.
F/W ver 2.20
1. Select [#ADJUST] -> [HEAD ADJUST] -> [STAGGER
ADJUST] from the operation menu.
2. Press the [ENTER] key to print the pattern.
[ENTER]: Starts printing the pattern.
[FUNCTION]: Cap OFF
[] / []/[] / []: enters into the jog mode (moves the
origin of the pattern)
3. Make to take off the cap on the head.
Do not perform this adjustment with the carriage
located on the Station Assy (cap). Make sure to take
cap off.
4. Check if the head is staggering.
Using a scope, check that the Headline1 and Headline2 patterns
overlap by 4-dots width. Check the same thing for the
Headline2 and Headline3 patterns. If the overlapped width is
improper, go to Head stagger adjustment procedure.
Tolerable range: 0 ± 10 μm
Remark
4.2.6
Rev.
1.0
1
2
3
4
5
6
7
8
R.1.0 P.2