MIMAKI SWJ-320 S2 Maintenance Manual page 67

MAINTENANCE MANUAL > Adjustment > Adjustment Items > [HEAD ADJUST] POSITION ADJUST
SWJ-320S
Model Issued 2013.03.08 Revised
4.2.7 [HEAD ADJUST] POSITION ADJUST
 Head position check procedure
<LOCAL>
width:1000mm
[FUNCTION]
FUNCTION
#ADJUST [ENT]
#ADJUST
HEAD ADJUST [ENT]
#HEAD ADJUST
POSITION ADJUST [ENT]
#POSITION ADJUST
PRINT START [ENT]
Tolerable range:
±
0
head 1
head 2
 Head position adjustment procedure
Head
Do not remove!
Head adjust tool
© 2013 MIMAKI ENGINEERING CO.,LTD.
1. Select [#ADJUST] -> [HEAD ADJUST] -> [POSITION
ADJUST] from the operation menu.
2. Press the [ENTER] key to print the pattern.
[] / []/[] / []: enters into the jog mode (moves the
origin of the pattern)
3. Make to take off the cap on the head.
4. Check if the space of pattern 1 is in compliance with the
specification.
10 μm
1. Loosen the two screws fixing the head to be adjusted.
2. Install the Head adjust tool to the head with the two screws.
F/W ver 2.20 Remark
[ENTER]: Starts printing the pattern.
[FUNCTION]: Cap OFF
[CLEANING]: Cleaning is curried out.
Do not perform this adjustment with the carriage
located on the Station Assy (cap). Make sure to take
cap off.
Be careful that back and forth positions of dots seen
with a loupe is opposite from the actual position.
Tolerable range: 0 ± 10 μm
When the dots are misaligned exceeding the tolerable range,
proceed to Head position adjustment procedure.
Do not remove the red screws in the figure since they
secure the AD plate and head.
Rev.
1.0
1
2
3
4
5
6
7
8
4.2.7 R.1.0 P.2