Riso 9630R User Manual page 190

Chapter 8 Optional Equipment
When Removing Printouts With
the Carriage
1
Press the stacking tray descent
button.
The stacking tray will be automatically lowered to its
lowermost position after approximately 3,200 to
4,000 (full) sheets have been output.
• Press the stacking tray descent button in a state
where the covers on both sides of the high
capacity stacker are closed. The stacking tray
will not operate if the covers are open.
• Once printing has ended, the stacking tray will
be automatically lowered to a position
configured by the administrator. To change the
position to which the stacking tray is lowered,
contact your administrator.
• If you accidentally press the stacking tray
descent button while printing, be sure to remove
the printouts. In a state where printouts exist on
the tray, the unit will not be capable of raising
the stacking tray to the position for output.
2
Open the right cover of the high
capacity stacker.
8-20
3
Pull out the carriage along with the
stacking tray on it.
• Slowly pull out the carriage while holding its
handle. Abruptly moving the cart may cause the
printouts to collapse.
4
Remove printouts from the carriage.
5
Return the carriage to the high
capacity stacker.
• Be sure to return the carriage in a state where
the stacking tray has been set.
6
Close the right cover of the high
capacity stacker.
ComColor GD Series User's Guide