Riso 9630R User Manual page 177

Staple
Staple at the specified position.
Types of paper that can be stapled
• Paper size: A3, B4, A4, A4-LEF
Ledger, Legal, Letter, Letter-LEF, Foolscap
182 mm -
297 mm
(7 3/16" -
11 11/16")
257 mm - 432 mm
(10 1/8" - 17")
2
• Paper weight: 52 g/m - 210 g/m
(14-lb bond - 56-lb bond)
Number of sheets that can be stapled
• Standard size paper
A4, A4-LEF, B5, B5-LEF (Letter, Letter-LEF):
2
2 to 50 sheets
Sizes other than the above (A3, B4 (Ledger,
Legal, Foolscap)): 2 to 25 sheets
1 Long Edge Feed
2 When using plain paper and recycled paper
2
(85 g/m (23- lb bond))
• When the printing job exceeds the maximum
number of sheets that can be stapled, a
confirmation screen is displayed so that you can
select whether to stop printing or continue
printing without stapling.
• Stapling cannot be performed when using
irregular-sized paper.
• The [Staple], [Booklet], and [Page Border]
functions cannot be used at the same time.
(p. 1-16 "Booklet", p. 1-19 "Page Border")
■ Original Orientation
[Top Side Up]
Select this option when loading originals in an orientation
from which they can be read normally.
[Top Side Left]
Select this option when loading originals so that the top
of the original is aligned with the left edge.
■ Binding Edge
Select the binding edge of the paper.
Left, Right, Top
1 ■ Staple
, B5, B5-LEF,
Select the stapling position.
If you select the left or the right for [Binding Edge], select
from the following options:
[OFF], 1 staple, 2 staples
If you select the top for [Binding Edge], select from the
Paper feed
following options:
and output
[OFF], left 1 staple, right 1 staple, 2 staples
direction
2
1
2
2
3
4
■ Binding Margin
You can specify the binding margin so that staples are
not in the printing area.
1
2
3
• The left 1 staple and the right 1 staple are
displayed only when the top is selected for
[Binding Edge].
Touch [Staple].
Configure [Binding Edge].
Configure [Staple].
Touch [OK].
Touch [Binding Margin] on the
[Staple] screen.
The [Binding Margin] screen is displayed.
Specify the binding margin.
• Select [Binding Edge].
• Use [ ], [ ], or the numeric keys to enter the
width.
• If part of the printing area is missing due to the
binding margin setting, set [Auto Reduction] to
[ON].
Touch [OK].
ComColor GD Series User's Guide
Face Down Finisher
8-7
8