Riso 9630R User Manual page 119

■ Entering the Number of Copies and
Sets
You can specify up to 9,999 copies and 99 sets per
group.
For example, to distribute a document to four divisions in
an office, you can use [Program] to print the required
number of sheets per division with a single operation.
Division General General
Affairs 1 Affairs 2
No. of 10 6
employees
To print the leaflets by group, configure the settings as
follows.
Division General General
Affairs 1 Affairs 2
Copies × Sets 10 × 1 6 × 1
Even if two divisions have the same number of
employees (such as General Affairs 2 and Management),
you can configure the settings as follows to print the
required number of sheets per division.
Group 01G
(General
Affairs 1)
Copies × Sets 10 × 1
In this case, specifying [Between Sets] for [Slip Sheet
(Program)] will make it easier to separate the bundles for
each department.
■ Sort
Specify whether to print page by page or in sets.
[Uncollated], [Collated]
■ Slip Sheet (Program)
Insert a slip sheet to separate printouts into specified
units.
[OFF]
Slip sheets are not inserted.
[Between Sets]
Slip sheets are inserted between sets.
[Between Groups]
Slip sheets are inserted between groups.
Accounting Management
24 6
Accounting Management
24 × 1 6 × 1
02G 03G
(General (Accounting)
Affairs 2 and
Management)
6 × 2 24 × 1
■ Slip Sheet Tray
[Feed Tray 1], [Feed Tray 2], [Feed Tray 3], [Standard
Tray]
■ Number on Slip Sheet
When this check box is selected, numbers are stamped
on the slip sheets.
If [Between Sets] is selected, the group number and set
number are stamped.
If [Between Groups] is selected, the group number is
stamped.
■ Offset Output (Program)
If you are using the optional face down finisher, high
capacity stacker, or multifunction finisher, you can
configure this item. For more information, see the
following:
• When using the face down finisher
(p. 8-6 "Offset Output (Program)")
• When using the high capacity stacker
(p. 8-24 "Offset Output (Program)")
• When using the multifunction finisher
(p. 8-35 "Offset Output (Program)")
ComColor GD Series User's Guide
Printer Driver Settings
3-29
3