Setting The Corrugators; Removing Printouts - Riso 9630R User Manual

Setting the Corrugators

As the state of paper transport and alignment will
differ depending on the size or type of paper being
used, adjust the corrugators so that the output and
paper of printouts will be aligned.
• Normally, it will not be necessary to adjust the
corrugators for printing. Adjust the corrugators
for better feeding and printout alignment.
• Paper alignment may not improve according to
the paper size, paper type, environment and
storage. For more information, contact your
dealer or authorized service representative.
Raising the Corrugators
Normally, the unit is used with the corrugators
raised.
1
Lift the front corrugator while
pressing it toward the machine (to
the left).
2
Similarly lift the back corrugator
while pressing it toward the machine
(to the left).
Lowering the Corrugators
The unit is used with the corrugators lowered when
printing on A3/B4/B5-LEF paper or thin paper.
1
Lower the front corrugator while
pressing it toward the machine (to
the left).
2
Similarly lower the back corrugator
while pressing it toward the machine
(to the left).

Removing Printouts

Remove printouts from the high capacity stacker.
There are two ways of removing the printouts.
• The printouts are to be removed when the
stacking tray is at a full stop. A message
indicating the status of the stacking tray is
displayed on the operation panel. Follow the
message.
• When removing printouts with the carriage
Remove printouts using the dedicated carriage for
the high capacity stacker.
• When removing only the printouts
Printouts can be removed without pulling out the
dedicated carriage. You can remove printouts
without waiting for the stacking tray to lower to the
bottom.
ComColor GD Series User's Guide
High Capacity Stacker
8-19
8