System Requirements And Specifications; Cabling; Figure 2-3 Connecting The Dlc Using Twisted 2-Pair Cable; Table 2-11 Dt300 Series Loop Resistance And Cable Length - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
S
S 5
YSTEM
ECTION
5.1
2 - 16
R
EQUIREMENTS AND

Cabling

This section provides cabling requirements and specifications for various
equipment used in the SV8100 system.

Figure 2-3 Connecting the DLC Using Twisted 2-Pair Cable

chassis connected with each of the multiline terminals and single line
telephones by a separate twisted 1-pair cable or 2-pair cable (only for multiline
terminals).
DLC
Figure 2-3 Connecting the DLC Using Twisted 2-Pair Cable
Refer to the following tables for cabling requirements and specifications.

Table 2-11 DT300 Series Loop Resistance and Cable Length



Table 2-12 DT700 Series Loop Resistance and Cable Length


term
Table 2-13 D

Table 2-14 Cable Connection Between the analogue Port and the Single

Line Equipment

Table 2-15 Cabling Requirements


Table 2-11 DT300 Series Loop Resistance and Cable Length
Terminal or Adapter
DTL-2E-1( ) (BK) TEL
DTL-6DE-1( ) (BK) TEL
DTL-8LD-1( ) (BK) TEL
DTL-8LD-1( ) (WH) TEL
DTL-12BT-1( ) (BK) TEL
DTL-12PA-1( ) (BK) TEL
DTL-12D-1( ) (BK) TEL
DTL-12D-1( ) (WH) TEL
S
PECIFICATIONS
Twisted 2-Pair Cable
Series i Terminal Loop Resistance and Cable Length
By Twisted
1-Pair Cable
(without AC
Adapter)
24 AWG
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
UNIVERGE SV8100
is a diagram of the
RJ-11
Multiline Terminal
SV8100 System Specifications