Figure 3-43 Brackets Secured In Mounting Position With Screws - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
3 - 36
5. Secure the bracket halves to the expansion fitting using the
four supplied screws (refer to
Brackets and Metal Expansion Fitting on page
6. Turn bracket assembly over and remove the screws holding
two brackets in the shipped position.

Figure 3-43 Brackets Secured in Mounting Position with Screws

7. Rotate the brackets into the mounting position. Using the same
screws, secure the metal brackets to the bracket assembly
(refer to Figure 3-43 Brackets Secured in Mounting Position
with Screws).
8. Remove the end brackets from the remaining two corners and
set aside (refer to
3-37).
Figure 3-42 9.5" Mounting
Figure 3-44 Remove End Brackets on page
Installing the SV8100 Chassis
UNIVERGE SV8100
3-35).