Figure 8-24 Raising The Height On The Dtr Multiline Terminal; Figure 8-25 Lowering The Base Plate On The Multiline Terminal - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
S 9 A
ECTION DJUSTING THE
The base plate on the multiline terminal is hinged to allow the height of the terminal to
be raised or lowered.
1.
2.
3.
System Hardware Manual
H
EIGHT ON A
Grasp in the middle of the hollow spaces at the top and pull up until the retaining
tabs click to raise the base plate. Refer to
DTR Multiline Terminal.

Figure 8-24 Raising the Height on the DTR Multiline Terminal

After the height is adjusted, pull the line cord though the groove in the bottom of
the multiline terminal and adjust it.
Push on the adjustment tabs on the side of the stand and push down to lower
the base plate. Refer to
Terminal.

Figure 8-25 Lowering the Base Plate on the Multiline Terminal

M T
ULTILINE ERMINAL
Figure 8-24 Raising the Height on the
Figure 8-25 Lowering the Base Plate on the Multiline
Issue 9.0
8 - 19