Wall Mounting The Multiline Terminal; Wall Mounting A Multiline Terminal Using The Base Plate; Adjusting The Hanger Hook; Figure 5-55 Removing The Hanger Hook On A Dt300/Dt700 Series Terminal - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
4.12
5 - 58

Wall Mounting the Multiline Terminal

You can wall mount a DT300/DT700 Series connection multiline terminal
using the base cover or an optional wall mount unit. A wall mount unit must be
used if adapters are installed on the multiline terminal.
When optional adapters are used, the multiline terminal must be installed on the wall using

the WM-L UNIT (refer to
4.12.1

Wall Mounting a Multiline Terminal using the Base Plate

4.12.1.1

Adjusting the Hanger Hook

1.
2.
3.
Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
5.2.7 WM-L UNIT on page
Remove the hook from the unit.
Hanger Hook
Figure 5-55 Removing the Hanger Hook on a
DT300/DT700 Series Terminal
Turn the hook with the tab toward the top.
Slide the hook until it glides into position forming the
hanger hook for the handset.

Figure 5-56 Sliding the Hanger Hook into Position

UNIVERGE SV8100
5-80).