Option 2 - Wall Mount Bracket (Keyhole) To Chassis - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
12. Refer to
page 3-18
paragraph
for installation of blades.
3.2.2 Option 2 – Wall Mount Bracket (Keyhole) to Chassis
1. Use the template shown in
Guide (9.5" Chassis) on page 3-28
drilling.
2. Mark and drill four holes.
3. Install four screws into the four drilled holes (refer to
3-41 Install Screws (Option 2) on page
2.4.2 Install AC Power Cord 9.5" Gateway Chassis on
to continue installation of the chassis or, Chapter 4
2.1 Installation and Safety Precautions on page 4-3
Figure 3-35 Wall Mount Spacing
Plywood should first be installed on the wall
where the chassis will be positioned. This
allows secure anchoring of the screws which
support the weight of the chassis.
Issue 9.0
for required spacing before
Figure
3-34).
3 - 33