Uninstalling A Blade Slot Through Software; Blade Capacities; Powering Up The Sv8100 System; Performing A Cold Start - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
2.4
2.5
2.6
4 - 8

Uninstalling a Blade Slot Through Software

The installer can turn off (busy out) and delete (remove from software) blade
slots in the Controlling and Expansion Chassis in programming for port
renumbering or to replace it with a different blade. Deleting a blade may affect
blade slot programming ability. Refer to Program 90-05 in the UNIVERGE
SV8100 Programming Manual for detailed programming information.

Blade Capacities

The universal architecture of the UNIVERGE SV8100 provides flexibility
when installing blades. With the exception of the CD-CP00, PZ-BS10, and
PZ-BS11 blades, any blade can be installed in any slot.
Maximum 9.5" Gateway and 19" System Capacities – Blades on page 2-9
(SV8100) provide a list of the blades and the maximum capacities with various
chassis configurations.

Powering Up the SV8100 System

2.6.1

Performing a Cold Start

This section describes the process for starting the system for the first
time or starting a system that has been turned off.
System software is loaded from flash memory, and the

customer data is loaded from RAM memory.
To avoid extension and trunk renumbering, if certain

blades are recognized first, remove them from their
respective slots until the system has been reset. Then,
slot the blade cards in the correct order to retain the
proper system numbering. (Use Program 10-03 prior to
performing a cold start to record the current slot
definitions.)
To perform a cold start:
1. Turn the system power off.
2. Once the system has powered down, push in and hold the
Load button.
3. Turn the power switch back on to power the system back up.
With a multi-chassis system, turn on the Expansion Chassis

power supply, then the Controlling Chassis power supply.
IMPORTANT CONSIDERATIONS
UNIVERGE SV8100
Table 2-4 SV8100
Installing the SV8100 Blades