Switch Settings; Led Indications; Figure 3-3 19" Controlling Chassis - Guides Slot 1; Table 4-16 Iplb Daughter Board Led Indications - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
Link 10
(LED 1)
LINK 100
(LED 2)
LINK 1000
(LED 3)
ACT
(LED 4)
System Hardware Manual
1. Turn off system power, and remove the CD-CP00.
2. Install the IPLB daughter board on the CD-CP00 blade.
3. Insert the CD-CP00 into slot 1 in the Controlling Chassis.
Refer to

3-8
4. Connect the IPLB daughter board to the CD-RTB or to an
external switching hub using an ethernet cable.
5. Refer to the UNIVERGE SV8100 Programming Manual for
detailed programming instructions.
3.5.3

Switch Settings

This daughter board does not have any switch that needs to be set
and does not require any hardware setting.
3.5.4

LED Indications

LED indications for the PZ-32IPLB, PZ-64IPLB and PZ-128IPLB
Daughter Boards are indicated in
LED Indications. Each LED is listed with its associated function and
LED and Operational status. Refer to
with Daughter Boards Installed on page 4-15
LEDs on the blades.

Table 4-16 IPLB Daughter Board LED Indications

LED Function
10 Base-TX link speed indicator
100 Base-T link speed indicator
1000 Base-T link speed indicator
Link activity or data transmission
and reception
Figure 3-3 19" Controlling Chassis – Guides Slot 1 on page
for more details.
Table 4-16 IPLB Daughter Board
LED Status
On Red
On Red
On Yellow
On Green
Figure 4-6 CD-CP00 Blade
for the location of the
Operation Status
10 Base-TX link up
100 Base-T link up
1000 Base-T link up
LED lights when link up is
completed. LED flashes
when data is transmitting
or receiving.
Issue 9.0
4 - 37