Wm-R Unit; Figure 8-39 Attaching The Wall Mount Unit To The Wall - NEC Univerge SV8100 System Hardware Manual

Issue 9.0
S 12 W
ECTION ALL
(WM-R U
The Wall Mount Unit is used to attach any DTR connection multiline terminal (except
the DTR-2DT-1 TEL) to the wall. This unit connects to the back side of the telephone.
When adapters are used, the multiline terminal must be installed on the wall using the

WM-R Unit.

1.
2.
3.
4.
8 - 28
M M
OUNTING A ULTILINE
)
NIT
Plug line cord in the wall receptacle. Leave about eight inches of cord and
bundle the rest.
Feed the line cord through the opening in the wall mount unit as illustrated in
Figure 8-39 Attaching the Wall Mount Unit to the
Attach the WM-R Unit using six screws.

Figure 8-39 Attaching the Wall Mount Unit to the Wall

Install the multiline terminal over the four tabs on the base cover, and push down
until it clicks in place as illustrated in
to the Wall Mount Unit.
T
ERMINAL USING THE
Wall.
Figure 8-40 Attaching the Multiline Terminal
Installing D
UNIVERGE SV8100
W M U
ALL OUNT NIT
term
Series i Telephones