Led Indications; Connectors - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
6.2.4

LED Indications

Active LED – Green
The Active LED is controlled by the DSP and indicates the board
operational status.
Off: Power off

On: Reset

Slow Flash: Board is running but not in sync with the chassis

Fast Flash: Board is in sync with the chassis and operating normally

Busy LED – Red
On: Application problem

CompactFlash Card Activity LED – Red
CompactFlash Card Activity LED is controlled by the IDE

controller and indicates read/write activity on the CompactFlash
card.
6.2.5

Connectors

Ethernet Connector
This connector is a single 10 Base-T/100 Base-T-X Mbps Ethernet
connector. This port has Auto-Medium Dependent Interface
Crossover (MDIX) to select either a straight-through or crossover
Ethernet cable for connection to a PC.
Issue 9.0
4 - 111